Parameters Category Parameter Specification for 07KT97F1 General Module Type Universal, Multi-Range Analog Input Module Compatible System ABB Freelance DCS, AC 700F/800F PLC, S800 I/O System Form Factor S800 I/O Single-Width Module Input Channels Number of Channels 8 channels (typical for this series). Channel Isolation Individual channel-to-channel and channel-to-system isolation. Analog Input Signals Configurable Types Voltage: 0-10V, ±10V Current: 0-20mA, 4-20mA (with 2-wire transmitter supply) Resistance: For RTDs (Pt100, Pt1000) Thermocouple: Types J, K, T, E, N, R, S, B Input Impedance Voltage: > 1 MΩ; Current: ≤ 250 Ω (internal shunt). Transmitter Supply 24 V DC (per channel, for 2-wire transmitters). Conversion & Performance Resolution 16-bit (or 15-bit + sign). Conversion Time Per channel: Typically 20 - 50 ms for all 8 channels (scan rate). Accuracy Typically ±0.1% of full scale (at 25°C, for voltage/current). RTD: ±0.2°C; TC: ±1°C (typical). Filtering Software-configurable digital filtering. Diagnostics & Alarms Diagnostic Functions Wire break (open circuit), short circuit, underrange, overrange, module fault. Status Indication LED per channel (green/red) for communication and fault status. Electrical & Environmental Backplane Power +5V DC from the S800 power supply. Field-Side Power 24V DC supplied to transmitters (if enabled). Isolation Voltage Channel-to-Bus: Typically 500 V AC (1 min). Operating Temperature 0°C to +60°C Storage Temperature -40°C to +85°C Relative Humidity 5% to 95%, non-condensing. Communication Bus Interface Profibus DP or Foundation Fieldbus (depending on the connected fieldbus module, e.g., CI871). Software Configuration Tool ABB Control Builder F (CBF) or Freelance Engineering.