Parameter Category Specification General Information Product Series Eaton Commander C Article Number / Model 130EMA-075CE22 Type Micro Drive, Variable Frequency Drive (VFD), AC Inverter Enclosure Rating IP20 (Open Type). Must be installed in a suitable enclosure. Standards CE, cULus, RoHS compliant. Designed to IEC/EN 61800 standards. Power Characteristics Rated Output Power 0.75 kW Output Horsepower (HP) 1 HP Input Supply (Mains) 1-Phase, 200-240V AC, 50/60 Hz Output to Motor 3-Phase, 0-240V AC, 0-600 Hz (maximum) Rated Output Current 3.8 A (This is the continuous current the drive can supply to the motor). Overload Capacity 150% of rated current for 60 seconds, 200% for 3 seconds (typical). Control & Performance Control Methods V/f Control (Voltage/Frequency), Sensorless Vector Control (optional). Frequency Reference Source Potentiometer (on keypad), analog input (0-10V, 0/4-20mA), preset speeds, Modbus communication. Command Source Keypad (RUN/STOP), digital inputs, or serial communication. Digital Inputs Typically 3 programmable digital inputs (sink/source). Analog Input Typically 1 (programmable as 0-10V or 0/4-20mA). Relay Output Typically 1 programmable relay output (changeover contact). Analog Output Typically 1 (0-10V configurable). Communication RS-485 Modbus RTU (standard). Optional cards for other networks (DeviceNet, Profibus). Switching Frequency Adjustable (typically 2-16 kHz) to reduce motor noise or system losses. Key Features Built-in DC bus choke, Auto-tuning (for motor parameter identification), multiple preset speeds, PID controller, braking transistor (for dynamic braking with external resistor), UL Type 1 kit option available. Motor Connection Recommended Motor Size 0.75 kW / 1 HP, 3-Phase, 230V AC induction motor. Protection Functions Overcurrent, short-circuit, ground fault, overvoltage, undervoltage, motor overload (electronic thermal), drive overtemperature, loss of phase. Physical & Environmental Mounting DIN Rail (35mm) or panel mounting. Dimensions (W x H x D) Approx. 55 x 146 x 136 mm (specific to frame size A). Ambient Temperature -10°C to +50°C (derate above 40°C). -10°C to +40°C for full rated current (check manual). Storage Temperature -40°C to +70°C. Relative Humidity < 95% RH, non-condensing. Altitude < 1000m without derating.