Parameter Category Specification General Information Product Series Eaton MVX9000 (also known as the "M-Max" series in some regions) Article Number / Model MMX12AA1D7F0-0 Type General Purpose AC Drive (VFD) Enclosure Rating IP20 / UL Type 1 (Open Chassis). Requires installation in a suitable control panel. Standards Compliance cULus, CE, RoHS. Compliant with IEC/EN 61800-5-1. Power Characteristics Rated Output Power 1.5 kW (Decoded from "12" in model number, where "12" often corresponds to 1.5kW/2HP frame). Output Horsepower (HP) 2 HP Input Supply (Line) 1-Phase, 200-240V AC (+10%/-15%), 50/60 Hz Output to Motor 3-Phase, 0-240V AC, 0-400 Hz Rated Output Current 7.0 A (This is the continuous current rating for the 1.5kW model). Overload Capacity 150% of rated current for 60 seconds. Control & Performance Control Methods Enhanced V/f Control, Sensorless Vector Control (SVC), Closed Loop Vector Control (optional with encoder feedback card). Frequency Reference Sources • Analog Input (0-10V, 0/4-20mA) • Digital Preset Speeds (via digital inputs) • Modbus Communication • Keypad potentiometer Command Sources Keypad, Digital Inputs, Serial Communication. Standard I/O • Digital Inputs: 4 programmable (PNP/NPN, sink/source) • Digital Outputs: 1 programmable (Open Collector) • Relay Outputs: 1 programmable (Changeover contact, 250VAC/30VDC 2A) • Analog Inputs: 1 (software selectable 0-10V or 0/4-20mA) • Analog Output: 1 (0-10V, configurable) Communication Ports • RS-485 (Modbus RTU protocol) - Standard. • Slot for Optional Communication Cards: DeviceNet, Profibus-DP, Ethernet/IP, etc. Switching Frequency Adjustable (typically 2 kHz to 16 kHz). Key Built-in Features • PID Controller with two sets of parameters • DC Braking and DC Injection Braking • Dynamic Braking Transistor (for external brake resistor) • Auto-Tuning (Static and Rotary for motor parameter identification) • Power Loss Ride-Through • Fan/Low Noise Control Mode • Multiple Motor Presets (up to 4 motors) Motor & Protection Suitable Motor Three-Phase Asynchronous Induction Motor, 1.5kW / 2HP @ 230V. Protection Functions Overcurrent, Short Circuit, Ground Fault, Overvoltage, Undervoltage, Motor Overload (Electronic Thermal), Drive Overtemperature, Phase Loss, Stall Prevention. Physical & Environmental Mounting Panel Mounting (with through-bolts) or optional DIN Rail kit. Dimensions (W x H x D) Approx. 73 x 180 x 155 mm (Varies slightly by frame; confirm with datasheet). Ambient Temperature -10°C to +50°C (40°C for full rated current; derating required above 40°C). Storage Temperature -40°C to +70°C. Relative Humidity 5% to 95% RH, non-condensing. Altitude < 1000m for full rating. Vibration 5.9 m/s² max.