Parameter Specification / Description Manufacturer & Model Eaton DGMFN-7-Y-A2H-32H-20 Valve Type Solenoid-Operated, Spring-Centered Directional Control Valve Series / Size DGMFN-7 (Size 07) Mounting Interface ISO 4401-07 (CETOP 7, NFPA D07) subplate Port Size (Main) Typically 1-1/4" SAE / 38 mm Metric (e.g., 1-1/4"-12 UNF or equivalent). Number of Positions 3-Position Number of Ways 4-Way (Ports: P, T, A, B) Spool Type Y – Specific Eaton spool symbol. This defines the internal flow paths in all three positions (left, center, right). Must be verified via catalog. Actuator Code -A2H-: Configuration with two solenoids (A2) of a specific type (H). Spring Code -32H-: Spring return to center configuration from both ends. Solenoid Type (Inferred) Wet-pin solenoid (common with H designation). Solenoid Voltage Common: DC12V, 24V, 110V, or AC options. The -20 suffix may indicate voltage (e.g., DC24V). Must be confirmed. Maximum Operating Pressure Up to 350 bar (5,000 psi) Rated Flow (ΔP = 10 bar) Approx. 150 - 200 l/min (40 - 53 US gpm). Critical to check catalog for exact flow rating of Size 07 with spool "Y". Maximum Recommended Flow Can be higher, depending on allowable pressure drop. Consult curves. Response Time Slower than smaller sizes due to larger moving mass. Typically 50 - 100 ms. Duty Cycle Continuous (100% duty cycle) capable with wet-pin solenoids. Electrical Protection Typically IP65 (with connector mated). Recommended Fluid Mineral-based hydraulic oils to ISO 11158 (e.g., HV46 or HV68). Required Filtration Minimum ISO 4406 19/17/14 recommended. Fluid Temperature Range -20°C to +70°C (-4°F to +158°F) for standard seals. Viscosity Range 10 to 400 cSt (50 to 2000 SUS) Weight (Approx.) ~ 15 kg (33 lbs)